what is a wormhole?

Wormholes are solutions to the Einstein field equations for gravity that act as "tunnels," connecting points in space-time in such a way that the trip between the points through the wormhole could take much less time than the trip through normal space.

The first wormhole-like solutions were found by studying the mathematical solution for black holes. There it was found that the solution lent itself to an extension whose geometric interpretation was that of two copies of the black hole geometry connected by a "throat" (known as an Einstein-Rosen bridge). The throat is a dynamical object attached to the two holes that pinches off extremely quickly into a narrow link between them.

This analysis forces one to consider situations...where there is a net flux of lines of force through what topologists would call a handle of the multiply-connected space and what physicists might perhaps be excused for more vividly terming a ‘wormhole’.

John Wheeler in Annals of Physics

Note to Visitors

The content viewed in this blog is a collection of various articles & newsletters and is placed only for educational purpose.

Monday, May 23, 2011

A.C Generator

HIGH SPEED PERMANENT MAGNET SYNCHRONOUS MOTOR / GENERATOR DESIGN:click here

A typical AC generator consists of a stationary stator and a rotor mounted within the stator (see below: Typical AC Generator). The stator contains a specific number of coils, each with a specific number of windings. Similarly, the rotor consists of a http://www.blogger.com/img/blank.gifspecific number of field poles, each with a specific number of windings. In addition to the rotor and stator, a generator has a collector assembly (usually consisting of collector slip rings, brushes, and brush holders). DC flows from the exciter, through the negative brush and slip ring, to the rotor field poles. The return path to the exciter is through the positive brush and slip ring.



Typical AC Generator

Rotor - The rotor contains magnetic fields which are established and fed by the exciter. When the rotor is rotated, AC is induced in the stator. The changing polarity of the rotor produces the alternating characteristics of the current. The generated voltage is proportional to the strength of the magnetic field, the number of coils (and number of windings of each coil), and the speed at which the rotor turns.

Stator - The frame assembly is the main component of the stator. Insulated windings (or coils) are placed in slots near an air gap in the stator core. There is a fixed relationship between the unit’s number of phases and the way the coils are connected. The stator in a four-wire, three-phase unit has three sets of armature coils which are spaced 120 electrical degrees apart. One end of each coil is connected to a common neutral terminal. The other end of each coil is connected to separate terminals. Conductors attached to the four terminals carry the current to the system’s switchgear and on to the load.

Collector slip rings -
Slip rings are usually made of nonferrous metal (brass, bronze or copper); iron or steel is sometimes used. Slip rings usually do not require much servicing. The wearing of grooves or ridges in the slip rings is retarded by designing the machine with limited end-play and by staggering the brushes. Surfaces of the slip rings should be bright and smooth, polishing can be performed with fine sandpaper and honing stone. Electrolytic action can occur at slip ring surfaces producing formation of verdigris. Verdigris is a greenish coating that forms on nonferrous metals. Electrolytic deterioration can be prevented by reversing the polarity of the slip rings once or twice a year. The stator of the three-wire, three-phase unit also has three sets of armature coils spaced 120 electrical degrees apart. The ends of the coils are connected together in a delta configuration. Conductors are attached to the three connecting points.

No comments:

Post a Comment

Collection of Books on Teaching Methods

Popular Posts